Valspar® Protective Sealer Natural Look

This sealer locks out weather and scuffs with a tough, penetrating layer of invisible protection.

  • Invisible finish, silicone-infused to protect without altering appearance
  • Seals out weather and household chemicals
  • Easy to apply, dries to the touch in 2 hours


Clear-Crystal Clear


1 Gallon, 5 Gallon


75 ft²/gal - 150 ft²/gal

Options may vary by retailer. Contact your preferred retailer for availability.


  • Usage
    Exterior aggregate, concrete, brick, pavers, masonry, mortar and flagstone. Do not use on garage floors.
  • Prep
    All surfaces must be clean, dry and free of all loose, peeling paint or contaminants. Bare concrete: New concrete, masonry surfaces and mortar should be cured 60 days. Previously sealed surfaces: Clean with an all-purpose cleaner (TSP or substitute). Previously sealed surfaces must be porous and able to accept additional sealer. Test surface porosity before sealing: Avoid using this product on nonporous, sealed surfaces. To test, place a few drops of water on the surface. If water sinks in, the surface is porous enough to use this finish. If water remains on the surface, do not use.
  • Application
    Use a roller or low-pressure, garden-type sprayer. While the first coat is still wet, apply a second coat to maximize protection. Allow 5–10 minutes for final penetration, then use a clean, dry cloth to wipe off all excess that did not soak into the surface. Do not pond or puddle this product.
  • Dry Time
    Dry Time @ 77 °F and 50 % Relative Humidity
    To The Touch: 1 hour - 1 hour
    Recoat: N/A
  • Clean-up & Disposal
    Clean up with warm, soapy water.
Recommended Coats
1 coats
Dry To the Touch*
1 hour - 1 hour
*Dry Time @ 77 °F and 50 % Relative Humidity

Data Sheets

Download the product data sheet (PDS) and safety data sheet (SDS) for your Valspar protective sealer natural look.

Product Number Base Container Size SDS PDS
080047241093 Clear 1 Gallon SDS PDS
080047241109 Clear 5 Gallon - -

Ratings & Reviews